CMB 10mm (between 1/2" and 3/8") with 90° elbow, fits 3/8" ID Hose, Includes Beer Nut

The CMBecker International Inline Flow Control 10mm Barb with a 90° elbow is necessary for those looking to use tubing that has an inner diameter of 3/8". It is slightly smaller than 1/2", but it will fit a 1/2" ID Hose if properly clamped.  Works perfect with the popular CMBecker Inline Flow Control!

• Stainless steel nipple, only stainless steel touches your beverage
• Works with CMBecker International shanks. 
• Includes CMBecker beer nut
• The size is 10mm which is between 1/2" and 3/8". When using with 3/8" hose you may need to slightly heat hose (using hot water) to stretch hose over barb (this is how we do it!) When using with 1/2" it will be loose, but we have used it with syphon hose and thicker high heat (EJ beverage or silicon) hose. Just make sure you clamp it properly to get a good seal.
• This will not work with a standard shank, it works with CMBecker shanks. These seal it two places and do not have a flat end (see photo) 

Draft Equipment/Hardware/Tailpieces;Draft Equipment/Shanks/Parts for Shanks;Draft Equipment/Shanks/Parts for Shanks/CMBecker Shank Fittings
CMB 10mm (between 1/2" and 3/8") with 90° elbow, fits 3/8" ID Hose, Includes Beer Nut