Blow-Off Hose Kit for Conical Fermenters

Fermenting a BIG BEER? Then you need a BIG blow-off kit!

Our standard (base) blowoff kit will help you prevent your aggressiver fermentations from clogging your airlock. Built with stainless steel parts and reinforced vinyl tubing, this kit gives you everything you need to replace your airlock and start brewing like the pros.

This kit comes with:

• 5 feet of 3/4" ID (1" OD)  vinyl hose
• 1 - 1.5" tri-clamps
• 1 - 1.5" tri-clamp silicone gaskets
• 1 -  1.5" tri-clamp to 3/4" hose barb adaptor

This kit will allow you to replace the standard stopper and airlock on your conical fermenter with a pro-level blow-off setup.

Note that this setup can cause the slightly restrict airflow if the hose bends too much. The hose should be supported by using the handle of the fermenter on its way down to the bucket. To ensure an open hose with no bend, check out our Deluxe Blow-Off Kit with 90 Degree Elbow.

Using a Blow-Off Hose Kit with a Conical Fermenter

Using the blowoff kit is easy. Rather than using the standard stopper and airlock, follow these simple steps:

1. Clamp the blow-off fixture and tubing to the fermenter lid using the provided tri-clamp and gasket.
2. Fill a bucket or large growler with Star San or any other sanitary solution.
3. Run the length of a tubing into the bucket, ensuring that the end of the hose is submerged.