High Pressure Hose

$41.95
(3 reviews) Write a Review
SKU:
HPH

For use to connect any secondary or primary regulator to the CO2 cylinder.

For a setup to use with right hand threaded regulators (Almost all secondary regulators including Taprite and Chudnow, also works with Chudnow Primary) use RG511R (includes part AD205!).

For a setup to use with left hand threaded regulators (Usually PRIMARY Taprite and others) use RG511L (note, most people use these with secondary regulators)

For any questions please email help@kegconnection.com or call 325-356-5204!

  • Six feet long with all fittings, Sleave protected ends, Rated to 2750 PSI
  • Nipple for CGA320 Valve with built in O-Ring (no CO2 washer required  (all CO2 Cylinders sold in the United States except pinvalve cylinders used in paintball)).
  • Outlet is 1/4" female flaired (FFL), but we supply nipple for your regulator.  Pick RG511R (all secondary regulators) or RG511L for Taprite Primary, (not secondary!, Taprite secondaries use RIGH HAND THREAD and you need to use a RG511R) 
  • Manufactured by Taprite using very high quality components. 

 WARNING: This product can expose you to Lead,  which is known to the state of California to cause cancer, birth defects and other reproductive harm. For more information go to: www.P65Warnings.ca.gov.

 

3 Reviews Hide Reviews Show Reviews

  • 4
    High Pressure CO2 Hose

    Posted by Dave on 29th Jun 2017

    The length was perfect, and the plastic sleeve worked great for keeping the sharp edges of the hole in the Kegerator from the hose.

  • 5
    perfect

    Posted by Unknown on 8th Dec 2014

    Kept trying to figure out how to relocate my co2 tank outside the keezer. Finally decided to check on keg connection. Voila they had it all worked in in one simple product.

  • 5
    Does the job

    Posted by Jason on 25th Mar 2014

    If you are looking to relocate your CO2 bottle outside of your kegerator this is the hose you need. It's 1/2" diameter and much more convenient to drill one hole in the side of your kegerator than several if your running more than one line. My dual regulator, and splitters are all inside the fridge with just this hose going between the co2 bottle on the outside and the primary regulator inside. Use gasket MR-200-1229 from western rubber & supply to create a good seal around the hose and fridge. You will need 2 gaskets since their are two layers of metal/plastic the hose passes through.