Sanke Tap to Homebrew Conversion Kit, no disconnects included

(1 review) Write a Review

This kit includes two 1/4MFL tailpieces, a 5/16 and 1/4 barbed swivel nut set (for connecting lines to Converted Sanke and disconnects on gas and beer lines) and two stainless worm clamps. To use this kit take beer and gas line off of your existing Sanke tap. Remove the tailpieces you removed line from and replace with the 1/4 MFL tailpieces in kit. Put 5/16 Swivel nut on your gas line and 1/4 on your beer line (for 3/16 line dip line in boiling water for 30 sec and it will slip on easily) then tighten down with worm clamps. You can now go between the Sanke tap and homebrew disconnects by unscrewing swivel nuts and screwing back on the connection you need. See Video on making this conversion at:

WARNING: This product can expose you to hexavalent chromium, also known as chromium 6 (Cr6),  which is known to the state of California to cause cancer, birth defects and other reproductive harm. For more information go to:


Videos Hide Videos Show Videos

1 Review Hide Reviews Show Reviews

  • 5
    Sanke Conversion kit

    Posted by Unknown on 1st May 2017

    It was what I expected. Easy to install. Good quality products. Will certainly purchase from Keg Connection again.